 |
|
|
|
|
|
| |
| |
|
|
|
|
| |
| |
|
|
The CMFs I am currently using are in 5nm steps from 360nm to 830nm,
which is 95 steps total.
Are there more detailed samples? Are there more detailed samples for D65
illumination too? The CMFs and illuminations should have the same number
of steps in the same range, since my script is set up to iterate through
both sets of samples at the same time. Not sure what to do if the sample
tables aren't the same sizes.
Thanks.
Mike
Post a reply to this message
|
|
| |
| |
|
|
|
|
| |
| |
|
|
On 3/21/2017 11:12 PM, Mike Horvath wrote:
> The CMFs I am currently using are in 5nm steps from 360nm to 830nm,
> which is 95 steps total.
>
> Are there more detailed samples? Are there more detailed samples for D65
> illumination too? The CMFs and illuminations should have the same number
> of steps in the same range, since my script is set up to iterate through
> both sets of samples at the same time. Not sure what to do if the sample
> tables aren't the same sizes.
>
> Thanks.
>
>
> Mike
Wikipedia says you can just interpolate between the 5nm points to
generate narrower ones. Lightsys uses a spline apparently.
Mike
Post a reply to this message
|
|
| |
| |
|
|
|
|
| |
| |
|
|
Am 22.03.2017 um 04:12 schrieb Mike Horvath:
> The CMFs I am currently using are in 5nm steps from 360nm to 830nm,
> which is 95 steps total.
>
> Are there more detailed samples? Are there more detailed samples for D65
> illumination too? The CMFs and illuminations should have the same number
> of steps in the same range, since my script is set up to iterate through
> both sets of samples at the same time. Not sure what to do if the sample
> tables aren't the same sizes.
http://cvrl.ioo.ucl.ac.uk/ provides some spectral data tables in steps
as small as 0.1nm.
I guess a lot of that is interpolated though. To my knowledge, the
original data was measured in steps of 5nm.
Post a reply to this message
|
|
| |
| |
|
|
|
|
| |
| |
|
|
Le 17-03-22 à 04:27, Mike Horvath a écrit :
> On 3/21/2017 11:12 PM, Mike Horvath wrote:
>> The CMFs I am currently using are in 5nm steps from 360nm to 830nm,
>> which is 95 steps total.
>>
>> Are there more detailed samples? Are there more detailed samples for D65
>> illumination too? The CMFs and illuminations should have the same number
>> of steps in the same range, since my script is set up to iterate through
>> both sets of samples at the same time. Not sure what to do if the sample
>> tables aren't the same sizes.
>>
>> Thanks.
>>
>>
>> Mike
>
>
> Wikipedia says you can just interpolate between the 5nm points to
> generate narrower ones. Lightsys uses a spline apparently.
>
>
> Mike
Yes, Lightsys use splines everywhere.
Most of the time, a linear spline is enough, but you may want to use
some other kind of spline.
Post a reply to this message
|
|
| |
| |
|
|
|
|
| |
