POV-Ray: Newsgroups: povray.advanced-users: How would i do a Mitt? means put two pipe together seamless at 90 degree.: Re: How would i do a Mitt? means put two pipe together seamless at 90 degree.

POV-Ray : Newsgroups : povray.advanced-users : How would i do a Mitt? means put two pipe together seamless at 90 degree. : Re: How would i do a Mitt? means put two pipe together seamless at 90 degree.		Server Time 29 Jul 2024 18:16:34 EDT (-0400)

From: Dan Johnson
Date: 25 Jun 2001 06:27:25
Message: <3B371282.7C2E7260@hotmail.com>

GrndAdmThrawn wrote:
> 
> I'm wondering how you would like take two cylinder at like 90 degree or 45
> degree  then put the end together but the end part would stick out of each
> others, how would u cut those end part off and delete it so the pipe like
> fits together without any gap or junk sticking out??
> 
> kind of like
> 
>     /|\
>   / / \ \
> / /     \ \
> 
> thanks in advance

You could use an intersection between an infinite cylinder from
shapes.inc and a plane.  I usually just stick in a sphere to close the
gap.  
-- 
Dan Johnson 

http://www.geocities.com/zapob

Post a reply to this message