"cshake" <cshake+pov### [at] gmailcom> wrote:
> When I try to put media in the air, all sorts of artifacts show up, especially
> when multiple light beams interact.
> Does anyone have any idea of how to fix this?

Tried to add some jitter to the media parameters?


> Relevant code info: using scattering type 2 (also tried isotropic with same
> results), low density media, light sources are spotlights with inverse square
> law fading.

An important info is missing: What's the pattern you're using (or did I overlook
this info somehow)?

If it's a high-res pattern with loads of details, I suspect you may have to
crank up the media sampling quality a good deal.

Post a reply to this message