"Thomas de Groot" <t.d### [at] inter nlDOTnet> wrote:
> If you want to experiment, I attached the original inc file to this message.
It is not surprising that you're having trouble; there are too many gaps in the
base object. Look at the cross-section in the image below!
You need to close these gaps, especially the thin gap across the centre and the
concave underside. Unless the square peg-hole has some special purpose I'd plug
this too. And don't forget to make sure it's a merge, not a union, or the
internal surfaces get hit first!
A default flattened sphere as inner object should work OK once you've filled the
gaps.
Hope this helps!
Bill
Post a reply to this message
Attachments:
Download 'coltest.jpg' (30 KB)
Preview of image 'coltest.jpg'
|
