"sooperFoX" <bon### [at] gmail com> wrote:
> You only need to do that if you want to cut the end off at an angle other than
> 90 degrees. Otherwise, you can just use the 'open' keyword in the cone
> definition.
>
> E.g.:
>
> cone {
> // .. whatever ..
> open // leave off the end caps
> }
>
> The same applies to cylinders too.
Of course, I had forgotten totally about that! Thanks for the info, well my
clipped_by count goes back down to zero. =)
-The Mildly Infamous Blue Herring
Post a reply to this message
|
