Kyle <hob### [at] gatenet> wrote:
> On Thu, 30 Nov 2006 22:06:32 -0500, Alain <ele### [at] netscapenet> wrote:
>
> >Good. My problem: the sides looks to thin. All the nuts that I have seen have
> >much thicker sides. Ether make the hole smaler or the body larger, keeping the
> >same hight.
>
> Thanks.  They are models after faucet shank nuts, which have thin sides and a flat
area in the rear
> with a smaller hole through it.
>
>
> Kyle


compression fitting nut then the end plate with the hole to take the pipe

hole should be a bit smaller. And a bit of scratching would not come amiss.
I would be interested to see the code for the isosurface.

Stephen

Post a reply to this message