>
> Very retro.  Nice job. Are the legs sphere_sweeps?

Thanks    They're torii and cylinders...  That was the probably the hardest
part for me... figuring out how to calculate it so everything would line
up.

> > Would iso surfaces be a good way to make the
> > necessary indentations in the tubing?
>
> Do you you mean, for the bolts? Or for where the legs meet the circular
> rungs? If the latter, subtracting torus objects from the legs at those
> points would look quite nice. (I guess the torii would have to be distorted
> in some way, so that the indents didn't go all away around the leg tubes.)
>
> Ken

I think there are bolts that have a rounded head and go in from the outside
so that the nut is inside/under the stool.  But on the outside, I think the
tubing had kindof an indentation to make room for the head of the bolt, so
the head was "kindof" flush with the tubing.  Not sure sure if that makes
any sense.

Post a reply to this message