ABX wrote:
>For those who trace my spline pachting. This time general_x_spline type with a
>lot of characteristics in one spline type available by setting freedom_degree...
>- control points with freedom_degree=-1.0 cause Catmul-Rom Spline
>ABX
>
Catmul-Rom? Like Catmul-Rom subdivision surface? Povray dosn't support true
subdivision surfaces yet right? ... Sure would be nice if it did.
Can't wait to see your patch, is it going to be distributed as a source
patch, or will you offer a binary too?
Post a reply to this message
|