POV-Ray : Newsgroups : povray.general : Help with thin object : Re: Help with thin object Server Time
4 Nov 2024 23:20:44 EST (-0500)
  Re: Help with thin object  
From: Jettero Heller
Date: 14 Aug 2003 12:12:48
Message: <slrnbjnd62.ntm.povfan@corky.voltar-confed.org>
>   A good way to achieve this is to use "+a0.0 +am2" settings for extra-good

Actually the images I posted in my temp dir are +a0.1 +am2 ... Do
you think the 0.0 will make a big enough difference?  (trying it
now).


OMG, that was it.  I had previously determined that anything
lower than 0.1 was just too darn low.

>   Firstly, the squares are not square. 
> standardized. This is because go stones ...

Yes... I didn't get that far cuz I was discouraged by the problem
above. :)  I will most definitely adjust for this later.  I'm
trying to get this thing as realistic as possible.  I'm an 17kyu
now.  

But for my first goban, I was a 38kyu and it shows:

http://www.voltar.org/povray/


But I've learned a LOT since then -- about gobans and about the
game.

> Secondly, your board lacks four hoshi-markers.

No, the stars are there... Tengen too, or am I crazy?

Anyway, thanks so much for your help.  That AA thing has been
bugging me for days!




-- 
If riding in an airplane is flying, then riding in a boat is swimming.
39 jumps, 8.0 minutes of freefall, 14.5 ff vertical miles.


Post a reply to this message

Copyright 2003-2023 Persistence of Vision Raytracer Pty. Ltd.