On Wed, 9 Oct 2002 16:03:39 -0700, "Tony Vigil" <tjv### [at] hotmailcom>
wrote:

>Does Rhino 1.0 unfold models?  I looked through the manual rather quickly,
>but I didn't see anything remotely similar.  

You can unroll a developable surface, but only if it is mathematically
possible to unroll it. I've done it a lot when I was making a couple
of molds out of sheet metal.

Of course, SolidWorks + SolidSheet is much better at it if you're
ready for the price tag (about $5000 IIRC :) )


Peter Popov ICQ : 15002700
Personal e-mail : pet### [at] vipbg
TAG      e-mail : pet### [at] tagpovrayorg

Post a reply to this message