In article <3d4fccd6$1@news.povray.org>, "Jeremy" <jer### [at] chmntcom> 
wrote:

> I built povray after downloading the new source last
> night. The build went ok after I edited the makefile
> a little bit. But when I ran the program I got an
> error about file permission and the povray.ini file.
> So I ran chmod a+rw /usr/local/etc/povray.ini
> then tried to run the program again, same message.
> At this point I went to look through the source code
> and noticed that there were two versions of POV_ALLOW_READ ...WRITE one in
> config.h and the other in frame.h. If I comment
> out the macros in config.h and rebuild, the program
> runs fine. I didn't look into it any further put thought
> I would post here. Hopefully some one can tell me
> the difference between the two declarations.

Look at the povray.unix group. There has been lots of discussion about 
this already.

-- 
Christopher James Huff <chr### [at] maccom>
POV-Ray TAG e-mail: chr### [at] tagpovrayorg
TAG web site: http://tag.povray.org/

Post a reply to this message