On Sat, 03 Jun 2000 12:01:51 -0700, ryan constantine wrote...
> where are uv steps set?  i remember seeing them somewhere, but at the
> time i didn't know what it was for.

[snip]

Select the patch object, and somewhere on the right hand options bar in 
Moray, there are a couple of boxes with spinners next to them which allow 
you to change U, V and flatness settings.

You might find it worthwhile setting flatness to 0 as well as upping the 
U and V settings.

Bye for now,
     Jamie.

Post a reply to this message