Nathan Kopp wrote in message <3582764D.9CB05720@ltu.edu>...
>OK. Being able to read a binary format might also be good, but I don't
think that
>introducing ANOTHER 3D format would be such a good idea. Maybe if we could
get
>POV to read DXF... but then there are copyright issues to deal with.
Copyright? There are lot's of programs out there that can read/write DXF
(including Thomas' 3DWin). I don't suppose they all asked Autodesk for
permission. As I see it DXF is a open format.
Anyway. Standard DXF is ASCII too. DXF-files with meshes are even larger
than POV-files with meshes.
Johannes.
Post a reply to this message
|