|
![](/i/fill.gif) |
On 07/03/2013 08:04 PM, Samuel Benge wrote:
> James Holsenback <nom### [at] none com> wrote:
>> Thanks twice ... I successfully separated the object into container,
>> lid, and top decoration.
>
> NP. Are you planning to make a boolean union of the lid and top decoration? I've
> found that Blender's boolean modifier can be dodgy at times, especially if the
> base mesh hasn't been triangulated.
>
>
Haven't even noticed the union modifier ... I /was/ going to just use
Join in object mode. I'll have a look!
Post a reply to this message
|
![](/i/fill.gif) |