Am 18.08.2011 07:21, schrieb Solar Mike:

> I was modelling a pop can using a couple bezier spline lathes and there is a
> reflection that does not look right to me.  I am confident the segment
> boundaries are straight but the reflection does not seem to match the curve.
>
> Am I just seeing things?  If not, where is a good place for me to start looking
> in the source (or is this a known issue?)

At boundaries between flat and highly curved surfaces, reflections can 
play some pretty surprising tricks with our eyes, so it may well be 
accurate after all.

Try to put some long narrow cylinder(s) at that particular place on the 
ground to see things more clearly; I somehow suspect that what you think 
is a single contiguous line may actually be two orthogonal lines.

Post a reply to this message