I need your expert comments :-)
This is the first serious render of the scene with radiosity. It is a 2-pass
job (first gathering radiosity data on an image half the size of this one;
took about 5+ hours; second pass was just about 45 minutes). There are still
ugly artifacts visible, especially on the columns. What is the best way to
go from here? I include the radiosity settings used so far. Normal and media
are off; Megapov settings were used
Thanks for the help!!
Thomas
//==== start code ====
radiosity {
//saving radiosity data:
#if (RadSave)
save_file "Oreille2.rad"
pretrace_start 0.01
pretrace_end 0.005
nearest_count 6
always_sample on
#if (MPov)
samples 1
adaptive 2
error_bound {0.1 adaptive 1.5, 50}
#else
error_bound 0.1
#end
//reading radiosity data:
#else
load_file "Oreille2.rad"
pretrace_start 1
pretrace_end 1
nearest_count 6
always_sample off
#if (MPov)
samples 1
adaptive 1
error_bound {0.1 adaptive 1.8, 20}
#else
error_bound 0.1
#end
#end
//common settings:
low_error_factor 0.5
gray_threshold 0
adc_bailout 0.01/2
minimum_reuse 0.015
count 150
brightness 1.0
recursion_limit 3
normal Nor
media Med
}
//==== end code ====
Post a reply to this message
Attachments:
Download 'Eavesdropping_wip06.jpg' (58 KB)
Preview of image 'Eavesdropping_wip06.jpg'
|