scott wrote:
>> "Shay" wrote in message
>> There *are* differences, however subtle, between this and what
>> would come out of a modeler.
> Surely it depends on the modeller? In something like ProEngineer you have
> lots of complex options to specify exactly what it does in the situations
> you mention, far more than I understand or have needed to use so far :-)
I did say "would" not "could". :)
Surely you could follow this exact same procedure in anything
sufficiently instructable. I'm only saying that you would have to know
exactly what you want and follow a specific procedure in contrast to
simply clicking "round edges".
-Shay
Post a reply to this message
|