|
|
> hello
> look at this image...
> http://moray.free.fr/images/lamborgini_test_udo_mesh.png
> same problem
As Lutz pointed out in m.w. the solution is:
"To rectify this, go to the mesh editor, switch to Point mode
(key 'P'), select all the points (key 'A') and then select Weld
in the Points menu on the Edit Tab. The threshhold should be
pretty small, and you shouldn't see any yellow lines on the
display. The number of vertices before and after
welding that are displayed in the dialog should also be different....
then click on OK and see if that fixes the subdivision problem."
It worked for me.
Txemi Jendrix
http://www.txemijendrix.com
Post a reply to this message
|
|