Just tried terminal mode/command line, rendered
.../scenes/advanced/balcony/balcony.pov. Ran fine, did it in 4min
50sec @ 512x384(took over an hour on my old P II, @ 320x240), and even
showed the stats (which it didn't before).
In Pyvon (v1.3, X/KDE) it still can't find the 'glass.inc' included
from 'table_stuff.inc', but looks like it is using a 'povray.ini' or
'.povrayrc' from somewhere.

Anyone know where I should look for the problem? A setting in Pyvon?
(I'm new to Linux, so please don't just say, "check *all* your *.conf
files". I feel 'lost' enough now!!)
Thanks.
I won't post this (OT) prob' in this thread again, I'll start a new
thread for any more questions [which I should have done to begin
with!!<G>]. I'm following a couple other older threads(in this NG)
about similar problems.

--
Bob R
POVrookie
--
MinGW (GNU compiler): http://www.mingw.com/
Dev-C++ IDE: http://www.bloodshed.net/
V IDE & V GUI: http://www.objectcentral.com/
POVray: http://www.povray.org/
Good C++ book: http://www.mindview.net/Books
alt.comp.lang.learn.c-c++: ftp://snurse-l.org/pub/acllc-c++/faq

Post a reply to this message