Ultimately, the mouth will be made from cutout shapes to match the mouth
openings in:

http://www.comet-cartoons.com/toons/3ddocs/lipsync/Phon-Typical.jpg

Making actual lips is doable, but I cannot figure out a way to have lips AND
my programmable lip-sync capabilities. That is, without having a
40-component mouth hole, and my interest is not in that degree of mouth
realism.

Ken couldn't see the existing gums because as I later discovered, the teeth
are actually too far back into the mouth, and the "hole" for the "mouth
interior" actually cuts through the lower jaw.

I'll try to have a great step forward before I post more of this dribble
ware....




"Aaron" <aar### [at] ihugconz> wrote in message
news:3dc75c44@news.povray.org...
> Yep... jaw looks much better!... now all you have to do is bring the top
lip
> down and the bottom lip up... so they meet in the middle... :)  Also as
the
> other post says... fill the lips out a bit too.
>
> Otherwise fantastic work!
>
>

Post a reply to this message