|
![](/i/fill.gif) |
"Corey Woodworth" <cdw### [at] mpinet net> wrote in message
news:3cb0bd95@news.povray.org...
> (ugh, I don't like making splines)
Is that because you can't figure out where your control points / nodes
should be?
Would a visual tool that created 2D splines for use in lathes, sors, prisms
be helpful? I am in the progress of playing around with such a tool, written
in VB, but am not sure if there would be much interest besides my own sense
of accomplishment.
Cheers!
Lieut_Data
Post a reply to this message
|
![](/i/fill.gif) |