|
![](/i/fill.gif) |
Psychomech wrote:
> Great work!
Thanks!
>but one thing isn't the corckscrew part on backwards???? all the ones i
> have had in the past had points at the end of the screw not where the screw meets
with
> the shaft.
Mine begins very thin, quickly grows and then slowly gets thinner, but not as thin as
it is at the beginning. The problem here is that if I made the screw a bit thinner it
would look too 'fat' (it sounds like an oxymoron, but it's true: as I reduced the
radius the screw looked more like a swirly candle). I played one hour with the
parameters of f_helix2 and got unpredictable results. This is the best compromise I
could get.
--
#local j=text{ttf"arial""JRG".2,0}#local J=0;#while(J<10)#local R=0;#while
(R<2)#local G=0;#while(G<1)#if(inside(j<R,G.1>))object{j scale.025translate
<R-1G-J/20J/-40+2>pigment{rgb<9J>}}#debug"O"#else#debug" "#end#local G=G+
.025;#end#local R=R+.05;#debug"\n"#end#local J=J+1;#end// JRG
Home: http://digilander.iol.it/jrgpov //New: Kitchen scene WIP
Post a reply to this message
|
![](/i/fill.gif) |