The predefined textures in woods.inc and textures.inc use the procedural
pattern -wood- which consists of concentric cylinders centred on the z-axis.
This means that if you want to see parallel veins you have to rotate it
properly. Try rotating the texture by 90 degrees in one direction (try for
example rotate 90*x). If it doesn't work, change the direction.
--
Jonathan.
"Will Hess" <nch### [at] ripline com> ha scritto nel messaggio
news:3bf98c79@news.povray.org...
> I'm trying to make a good wood-grained surface as a floor to pose models
on.
> Are there any tutorials on how to do this? I've tried to use the woods in
> woods.inc and textures.inc but I can never get the grains to run
> parallel...they just show up as rings.
>
> Any help will be greatly appreciated.
>
> Thanks,
> Will
>
> Bricksburg Fire Department: www.bricksburg.org
> GoB Bricksburg Depot: http://www.brickbay.com/store.asp?p=willhess
>
>
Post a reply to this message
|