I'm trying to write a macro to create a chain that follows a spline and I've
run
into a problem. As far as I can tell there is no way to get the value of a
spline
at equal distances along it.

Does anyone know of a way to place objects at equal distances along
a spline, short of trial and error?

Gail
--
*************************************************************************
* gsh### [at] monotixcoza                *   Step into the abyss,           *
* http://www.rucus.ru.ac.za/~gail/   *   and let go.          Babylon 5 *
*************************************************************************
* Just think of me as the storm before the calm     Magic: The Gathering*
*************************************************************************

Post a reply to this message