"Thomas Lake" <tla### [at] homecom> wrote :
>
> Yeah I saw those and I know how to correct them, but I'm not sure Rhino
will
> allow me to join them. I find that sometimes when you make a model you
arn't
> able to join two surfaces even though the surfaces have been made just so
> that they should join. Also this image took over a day to render so I'll
> have to think about it.

    You may already know this, but I find that "analyze" > "edge tools" >
"show naked edges" and "join two naked edges" helps in a lot of cases.

Post a reply to this message