|
![](/i/fill.gif) |
Jonathan Rafael Ghiglia <j.l### [at] libero it> wrote:
> What's the difference between the float value which follows the
> pattern type (inside a normal statement) and the bump_size value?
> Which one should I play with in order to control the amount of
> perturbation? Can I set an accuracy value for normal patterns
> (to get better results with patterns which are not likely to be used
> as normal patterns)?
Specifying a float after the pattern name is simply a shortcut for
specifying a bump_size value - there is no difference in the rendering, and
either can be used to control the amount of perturbation.
As for accuracy, this is generally determined only by the rendering
resolution - all POV-Ray's internal patterns are algorithmic, and can be
scaled to any reasonable size without degradation (barring precision limits,
and a small bug with the current implementation of "noisy" patterns).
Level of detail becomes important with image based patterns (i.e. bump_map),
for which POV-Ray offers the interpolation feature, and turbulence that you
add to patterns. With turbulence the detail is determined by the settings
you use - generally, increasing the octaves value should add extra, smaller
perturbations which you might want if viewing a pattern very closely.
Post a reply to this message
|
![](/i/fill.gif) |