thank you einstine for the big image i REALLY liked downloading a 1024x768
image to see a tinny little foul up. was it so hard to use an image editor and
crop it?!

"Lt. Kettch" wrote:

> I am trying to put two cylinders together, but the red over laps onto
> the gray(90) and vice-verca. How do I crop the over lapping parts with
> out leaving a big hole in the finished item? BTW the gray that sticks
> out the back of the red doesn't matter.
>
>   ------------------------------------------------------------------------
>  [Image]

Post a reply to this message