Bob Hughes wrote:
> 
> And for the more "on your own" method as was asked for:
> 
>  http://www.eossystems.com/Lite/
> 
> Check that web page out, there's a free demo of a program to make photos
> (drawings possible too) into a 3D model (DXF). You supply a few pictures
> of a object from various perspectives (viewing angles) and the manual
> creation of the model vertexes, lines, and surfaces is also up to you.
> Well, just take a look and try it out, you'll see. The setup really
> needs a digital camera, not sure if you can get around that. Seems the
> setup allows for various ways to setup though. Been a while since I
> tried it.
> Mike Hough brought it up at AOL once and that's how I know of it and I
> later saw it there in AOLs software libraries. It seems quite a good
> program, just not super simple.

  Ok Bob.  He can use the model I provided a link for as an example of
physical demensions and digitaly photograph it using Pov from any angle
needed :)

-- 
Ken Tyler
  
mailto://tylereng@pacbell.net
http://home.pacbell.net/tylereng/links.htm

Post a reply to this message