|
![](/i/fill.gif) |
Hi,
Could someone guide me through the steps necessary to make a "square
rod" (a cube with a square hole in it), please?
If possible, could you also point me wich parameter(s) would be
responsible for setting the "size of the hole" (or the thickness of the
walls of the rod), please?
I'm new to Moray, and the documentation on Translational Sweeps wasn't
enough (for me, at least) to grasp the technique...
Thank you in advance,
Andre.
P.S.: I'm using Moray 3.1 (Build 4325) on NT4.0.
--
=================================================================
Andre Philippi - Applications Developer | Phone: 626-296-5016
phi### [at] corp earthlink net | Fax: 626-296-5113
Earthlink Network, Inc. | 3100 New York Drive
http://www.earthlink.net | Pasadena, CA 91107
=================================================================
Post a reply to this message
|
![](/i/fill.gif) |