Hello,
    I've been using the moray keyframe/rendering plugin for a little
while, and I must say it's very cool.  Usually it works perfectly, too.
But recently I set up a scene, keyframes & all, and when I clicked
"animate", Moray hung for a few seconds and then crashed.  I had the
same result when I just clicked "render".  The only weird thing in the
scene was a translational sweep -- would that screw things up?
    Another weird thing to report:  sometimes when opening up a scene
with keyframes, it gives me this message: "The following plugin has read
a different amount of bytes from the file than it informed Moray it
would.  You can choose to correct the file position (recommended), or
you can leave the file position where it is."  Even when I clicked
"correct file position", it happened again later.  What's going on?
    Sorry for posting as my question's probably been answered already,
but I did look for an answer in previous postings!  Really!

Joe Prever

Post a reply to this message