Wayne Earl wrote:
>
> I use Moray for Windows with POV-Ray 3.01 to do 3d prints. I was
> wondering if there was a way to increase the dpi settings in the
> renderer, to reflect the dpi of my printer? I've not been able to do
> this.
This is a bit odd question. As far as i know dpi is never saved in the
targa-file that povray gives as result of a rendering.
Although the confusion is understandable.
DPI means dots per inch. For a standard monitor the value is 75. If you
print a 800*600 image that takes a full screen it wil only take a few
inches on a 300dpi printer. It will only be smaller on paper than is on
the screen. but thats' all.
There is no need to set this value, just make a large enough image and
use a decent graphics-program to print this image. It will definitaly
look well.
--
Peter O
---------------------------------------------------------------
no-### [at] kotnetorg
You're nobody until somebody loves you. (James Dean)
---------------------------------------------------------------
http://www.gv.kotnet.org/~nbody
Post a reply to this message
|