|
|
On Sun, 28 Mar 2004 17:11:16 -0500, "Steve Shelby"
<ssh### [at] rexnetnet> wrote:
>Here's a situation that I just had that I found frustrating. I selected a
>group of faces, which was a rather long and laborious process. I wanted to
>assign a different material to those faces, using UV mapping. Unfortunately,
>the material I wanted to use had not been moved to the list, so I had to go
>to "modify" which meant I lost all the selected faces, and had to go through
>the process of selecting them all over again. It sure would be nice if
>selected faces or points could stay selected when switching to "modify" and
>back.
>Steve Shelby
>
I experienced the same frustration a lot of times, and I pointed that
out in a post a few weeks ago.
Lutz said, that selections would stay persitent between TAB-switches,
in the next update-release.
Bernd
Post a reply to this message
|
|