I'm pretty new to news groups so tell me if I do something wrong...
I went to use povray last night and for some reason pvengine.exe causes a
page fault in module unknown.  I'm not sure which ver was installed at the
time because the first thing I did was reinstall it.. I'm fairly sure it
was ver 3.02.  Anyway, the last time I used povray at home was about 2.5
months ago (worked fine then) as I usually use povray at work (on the
'fast' computers).  
It comes down to this: ver 3.02 will run, but crashes when you start a
render (at the point where it would normally pop up the display window,
scene parses fine).. ver 3.00e however runs fine.. At work I have the exact
same problem, ver 3.10 runs fine.

any ideas?/known bugs
-Cedar

ps. Personally I miss Maximinimise, and I don't like the fact that you have
to save a file in order to render it in V3.10.. (unless I havn't found the
peticular option yet)

Post a reply to this message