|
|
"Usb Hub" <nomail@nomail> wrote:
> Now it works! The solution is, that the direction of the tangents at the start
> and end control point of joining curves must be identical.
> (http://wiki.povray.org/content/HowTo:Use_Splines_and_Bezier_Curves)
Yes, if you're piecing together splines, then you need to do that to make them
smoothly continuous.
> But now is the question, how can I make edges in the spline?
What do you mean "make edges"?
Do you want just a "linear" spline that doesn't "enclose a shape"?
Post a reply to this message
|
|