|
 |
Considering 3.5 possibility of changing type of splines on-the-fly I suppose all
control points are strored with spline identifier. So why not add transformation
modifier for splines ?
for example
#declare S=spline{
cubic_spline
Val_1, <Point_1>[,]
Val_2, <Point_2>[,]
...
Val_n, <Point_n>
rotate x*90 // rotate control points 1..n
Val_n_1, <Point_n_1>[,]
Val_n_2, <Point_n_2>[,]
...
Val_m, <Point_m>
translate y*2 // translate control points 1..m
Reorient_Matrix(y,x+z) // trnsformation from "std.inc"
}
it can be done by hand with #if, #macro, loops etc. but since parsing is the
slowest part then it could improve speed
ABX
Post a reply to this message
|
|
