|
 |
I was just reading the POV-Ray help file in the RC3 Windows version about the
radiosity save_file / load_file deprecation and see this:
Radiosity_File_Name="" or +RF"" to set the cache file name;
Radiosity_From_File= or +RF to enable reading the radiosity file at startup
Radiosity_To_File= or +RFO to enable writing new samples to the radiosity file
....
If both +RFI and +RFO are specified, new samples gathered are appended;
otherwise, +RFO causes the file to be overwritten if it exists.
Maybe you've caught & fixed this already, but the command line param for
Radiosity_From_File should be +RFI instead of +RF.
-------------------------------------------------
www.McGregorFineArt.com
Post a reply to this message
|
|
|
|
On 03/05/2011 06:09 PM, Robert McGregor wrote:
> I was just reading the POV-Ray help file in the RC3 Windows version about the
> radiosity save_file / load_file deprecation and see this:
>
> Radiosity_File_Name="" or +RF"" to set the cache file name;
> Radiosity_From_File= or +RF to enable reading the radiosity file at startup
> Radiosity_To_File= or +RFO to enable writing new samples to the radiosity file
> ....
> If both +RFI and +RFO are specified, new samples gathered are appended;
> otherwise, +RFO causes the file to be overwritten if it exists.
>
> Maybe you've caught & fixed this already, but the command line param for
> Radiosity_From_File should be +RFI instead of +RF.
>
> -------------------------------------------------
> www.McGregorFineArt.com
>
>
>
nope i didn't ... thanks Rob
Post a reply to this message
|
|
