Hi This may be known but I can't see anything in the groups on it and it didn't happen
in beta 9.

When setting the output to png with  +fn +c on the command line I get the following
error message and a load of multi coloured junk.

"Possible continue trace error cannot read png data.

Mick

Post a reply to this message

"Mick Hazelgrove" <mic### [at] mhazelgrovefsnetcouk> wrote in
news:3c487cf8@news.povray.org: 

> When setting the output to png with  +fn +c on the command line I get
> the following error message and a load of multi coloured junk. 

I get the error message but the trace continues normally.  I see no 'multi 
colored junk.'

Post a reply to this message

The unrendered space instead of being grey and white squares is full of coloured dots,
almost like a single line of pixels has been
spread all over the unrendered area.
I get a message rendering line 0 of 300(for example) then after a while it crashes and
staps rendering.

Mick

"Coridon Henshaw" <che### [at] sympaticoca> wrote in message
news:Xns### [at] 204213191226...
> "Mick Hazelgrove" <mic### [at] mhazelgrovefsnetcouk> wrote in
> news:3c487cf8@news.povray.org:
>
> > When setting the output to png with  +fn +c on the command line I get
> > the following error message and a load of multi coloured junk.
>
> I get the error message but the trace continues normally.  I see no 'multi
> colored junk.'

Post a reply to this message

"Mick Hazelgrove" <mic### [at] mhazelgrovefsnetcouk> wrote in message
news:3c487cf8@news.povray.org...
> Hi This may be known but I can't see anything in the groups on it and it
didn't happen in beta 9.
>
> When setting the output to png with  +fn +c on the command line I get the
following error message and a load of multi coloured junk.
>

Confirmed, win98, athlon 1.33Ghz, 512mb ram, intel compile

Kev

Post a reply to this message