|
|
"Melody" <nomail@nomail> wrote:
> OIC now. Must weld and then subdivide - Smooth pops in,
> so many combinations of buttons, so little time.
> Not seen in this image were some shaved off corners from the subdiv.
> You can see that front piece is now rounded.
Still learning. This is not POV Smoothing - this is, stick all pieces in a sand
tumbler for a week. rounded off everywhere, what's different; Crease angle?
I knew PoseRay was awesome. I am not smart enough to write anything that good.
Barely got the brains to use it.
Post a reply to this message
|
|