|
 |
"omniverse" <omn### [at] charter net> wrote:
> [in 3.7.1 beta 7]
> The linear has only minor trouble; and the b_spline, while almost as bad as
> cubic, will clean up entirely if tolerance 0.1 is used.
>
> However, nothing rids the linear type of the smaller artifacts seen on the right
> end of this sphere_sweep. I tried small tolerance and large tolerance and it's
> appearance stays the same.
>
Those linear_spline sphere_sweep artifacts are a suprise (to me.) I never
noticed them before (I always thought linear_splines were well-behaved.) Does
moving the camera around change their location? If you can run the older v3.62,
do they show up there as well?
Post a reply to this message
|
|
