"davidafisher" <dav### [at] coppernet> wrote:
....
>  CenS     = 197610.0310786000, 11.1000000000, -695109.5844980000
>
>  my plan was to radiate out from this spot and place grass patches to help in
> the depth of field. As you can see from the x,z coordinates using <0,0,0> as a
> trace point would not work (glancing blow or some other part of the topography
> might intercede), so I set two points one above and one below the terrain by
> adding and subtracting 50 to the y coordinate.
>
>    new_up = 197610.0310786000, 61.1000000000, -695109.5844980000
>
>  new_down = 197610.0310786000, -38.9000000000, -695109.5844980000
> run the trace
> #local clump_position  =  trace (landmass,new_up, new_down,TraceNorm);
>
> as a test trace between these two points you would think I would get the
> original CenS value, but this is what I get:
>
>  TraceNorm      = -0.0852216709,  0.9928279034,  0.0838452206
>  clump_position = 198132.9729394691, 60.9970576631, -696949.0756293016
>
> a difference in x of 522.9418609 and z of -1839.491131
>
> What is it that I don't understand about trace?

trace() uses a direction vector <0,-1,0>, for example.

trace(Object_identifier, Start_point, Direction, Vector_ident)

Stephen S

Post a reply to this message