Stephen <mcavoys_at@aoldotcom> wrote:
> On 28/02/2011 8:22 PM, Jim Holsenback wrote:
> > On 02/28/2011 03:56 PM, Silverlight2009 wrote:
> >> How can I change the output file's location on Windows?
> >>
> >> Thank you.
> >>
> >>
> > here's one way:
> >
http://wiki.povray.org/content/Documentation:Reference_Section_1.1#Output_File_Name
>
> Is there not a line that can be put in povray.ini similar to
> Library_Path? I'm sure there used to be.
>
> --
> Regards
>      Stephen

From the wiki:
Output_File_Name=c:\(folders)\

(note the end slash).  This will create the output image as
"scenename"."filetype"  in the folder indicated.  Perhaps a bit misleading by
its name though that it's not "Output_File_Path"

-tqg

Post a reply to this message