very nice. I always play it looped for a while, because there is always so
much to see in your animations. the swirl in the fluid, at the etch of the
object are very nice.

just a few notes:
-it's difficult to see, but it looks like the cup still ends up spinning
faster and faster. do you simulate friction between the object and the
water surface?
-it looks like either the density of the wood is very low (more like cork)
or the density of the fluid is very high. (more than water). this results
in that the speed of the object is affected mostly by all the waves tossing
it around, since it's own mass and inertia is very small. and the cup does
ot sink into the water very far at the end of the animation. are you using
realistic densities for your simulations?

Post a reply to this message