Mike Williams <nos### [at] econymdemoncouk> wrote:
> I can't seem to access that file. "Server does not exist".

Works for me. Maybe you tried too soon? It took me a minute after I posted
to get it online.

> Is it possible that you're using a cubic_spline and have missed the fact
> that the end control points lie outside the spline:

Like Bob mentioned, I'm using quad splines.

I was under the impression, tho, that I didn't need control points with
quadratic splines. That's what I thought I read in the documentation. I
just happen to have a 2-hour car ride ahead of me today, so I'll re-read it
and try again.

-Mike

Post a reply to this message