I tried to run benchmark again just to check the out put file. (benchmark
..ini was already set up so that it does not generate the output into a
file. But I somehow I wanted to get this image rather than just viewing
from the site.

Ok...I changed the one of the option in benchmark.ini file. (changed Off to
On for out put to file)

Then I typed the following command in the terminal.

            povray benchmark.ini benchmark.pov +L......


I though it would work but.....After sorting photons the terminal says File
Init Error: Cannot open output file".


Do I need to correct other settings?

Post a reply to this message