Phil Clute wrote:
>I have a head model made in spatch/hammapatch
>that, once scaled down, has a hole in the face.
>I seem to recall a fix for this but I can't remember
>what.
>
>Phil
>

I remember reading that these problems often occur due to roundof errors
(and i have experienced simmilar problems that occured when changeing
the detail-level when describing a surface - i.e. for triangles at
a specific size caused strange lines in my surfaces).

The remedy was to change the scale factor a little bit (either up or down).

If this does not work, you could laborate with moving the camera back
instaed of scaling down the picture


Hope any of the above  works in your case,

Jan

Post a reply to this message