|
 |
On Wed, 14 Nov 2007 21:19:06 EST, "Kirk Andrews" <kir### [at] tektonart com> wrote:
>Here's the problem:
>
>> #declare o_Rod =
>> superellipsoid {
>> <1, **0.05**>
>> scale <1, 1, 7>
>> }
>
>Unfortunately, if you go too small on one of the dimensions, it makes artifacts.
> You'll have to bump up that second parameter a little bit. Someone wiser than
>I may have a better solution, but I know of none.
>
Hmm, I still get small artefacts in the same spot as high as 0.25 on the second
parameter, and the
object is then not shaped as I'd like.
I guess I can always just merge a couple of cylinders and tori as a means to an end.
Post a reply to this message
|
|
