|
|
Wasn't it jasius who wrote:
>No good. Below is the part of output:
>
>// -- Coming now: 860 bonds --
>
>
>union {
> cylinder { <-1.436494,-2.677406,2.422070>, <-0.506810,-4.051990,1.579784>,
>0.000000 material { M_BD0 } } // #16: "Al1" -- "O1"
> cylinder { <-1.436494,-2.677406,2.422070>, <-0.714979,-1.184693,1.579784>,
>0.000000 material { M_BD0 } } // #17: "Al1" -- "O1"
> cylinder { <-1.436494,-2.677406,2.422070>, <-3.087694,-2.795534,1.579784>,
>0.000000 material { M_BD0 } } // #18: "Al1" -- "O1"
> cylinder { <3.313506,-2.677406,2.422070>, <4.243190,-4.051990,1.579784>,
>0.000000 material { M_BD0 } } // #19: "Al1" -- "O1"
> cylinder { <3.313506,-2.677406,2.422070>, <4.035021,-1.184693,1.579784>,
>0.000000 material { M_BD0 } } // #20: "Al1" -- "O1"
> cylinder { <3.313506,-2.677406,2.422070>, <1.662306,-2.795534,1.579784>,
>0.000000 material { M_BD0 } } // #21: "Al1" -- "O1"
I did say to check that the bond radius setting was sensible.
>> Also: check that you have a sensible value for the bond radius
>> (Picture->Model And Radii)
Change it from "0" to something like "0.05" Angstroem.
--
Mike Williams
Gentleman of Leisure
Post a reply to this message
|
|