> How can you
> 
> 1. Add a point into a line

Same way as in sPatch.  Select the Patch tab, select the add point tool, 
click on one of the points already existing on the line and work from 
there, or the other route is to select the line you want to add the point 
to, using TAB.  Delete the line, add a new point halfway along the line 
and then weld it to the existing points at each end of the old line.

Did that make any sense?
 
> 2. join points

Same way as in sPatch <grin>

Using the move tool, move the point over the point you want to weld it 
to, then, whilst holding down the LMB, click the RMB.

Bye for now,
     Jamie.

Post a reply to this message