On 21/02/2026 20:34, Bald Eagle wrote:
> Now I can move on to learning the Bambu P1S and hopefully not have it rip the
> print off the base after 2h into the print.
> 

There are few tips to avoid this unpleasant event:

1. Keep printer from drafts - environment temperature should be as
stable as possible.
2. Increase the temperature of the first layer if software allows.
3. Increase extrusion of the first layer ...
4. Try to use brim.

If nothing of the above helps read software instruction ).

> And then maybe implement the AMS so that I can do fancy multi-color printing.

It should be interesting ...
--
YB

Post a reply to this message