|
|
On 12/08/2018 02:36, Bald Eagle wrote:
> Raising the internal 4 control points gives a Y-paraboloid, and then I inverted
> the right two, and got this.
>
> I kinda want to 3D print it and use it as an ice cream spoon.
>
>
>
> Raising the internal 4 control points gives a Y-paraboloid, and then I inverted
> the right two, and got this.
>
> I kinda want to 3D print it and use it as an ice cream spoon.
>
These shapes are so attractive.
I would use it as part of a wind chime, made of crystal glass.
--
Regards
Stephen
Post a reply to this message
|
|